punchline
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
punchline [2022/05/20 20:13] – [Schematic and Interconnection] wadmin | punchline [2022/05/20 21:35] – [Controls] wadmin | ||
---|---|---|---|
Line 19: | Line 19: | ||
==== Controls ==== | ==== Controls ==== | ||
+ | * Button controls | ||
+ | * Mode | ||
+ | * Press = Cycle | ||
+ | * Tap Tempo | ||
+ | * Fixed 0.5s< | ||
+ | * Fixed 0.15s< | ||
+ | * Fixed 0.04< | ||
+ | * Hold = Reverb Setup | ||
+ | * Tail On/Off | ||
+ | * Center Ring Controls | ||
+ | * Delay control | ||
+ | * Feedback | ||
+ | * Time | ||
+ | * Filter | ||
+ | * Reverb control | ||
+ | * Low RT60 : Zita model Low frequency RT60, cutoff frequency at 400Hz, 1 to 8 second long | ||
+ | * High RT60 : Zita model High frequency RT60, cutoff frequency at 400Hz, 1 to 8 second long | ||
+ | * Damping : High frequnecy damping | ||
- | * Delay control | + | ==== Color Coding |
- | * Feedback | + | {{drawio> |
- | * Time | + | |
- | * Filter | + | |
- | * Reverb control | + | |
- | * Low RT60 : Zita model Low frequency RT60, cutoff frequency at 400Hz, 1 to 8 second long | + | |
- | * High RT60 : Zita model High frequency RT60, cutoff frequency at 400Hz, 1 to 8 second long | + | |
- | * Damping : High frequnecy damping | + | |
- | + | ||
- | ==== Mode Tap Signature | + | |
- | {{drawio> | + | |
==== Schematic and Interconnection ==== | ==== Schematic and Interconnection ==== | ||
Line 36: | Line 45: | ||
{{ : | {{ : | ||
- | ^ Signal ^ Pin ^ Functional ^ | + | ^ Signal ^ Pin ^ Functional |
- | | Pot 1 | 18 | A0 | | | + | | Pot 1 | 18 | A0 | Feedback control |
- | | Pot 2 | 20 | A2 || | + | | Pot 2 | 20 | A2 | Time control |
- | | Pot 3 | 21 | A3 || | + | | Pot 3 | 21 | A3 | Filter control |
- | | Pot 4 | 26 | A8 || | + | | Pot 4 | 26 | A8 | // |
- | | GND | 1 | GND || | + | | GND | 1 | GND | GND | |
- | | Punch | 2 | 0-RX1 || | + | | Punch | 2 | 0-RX1 | Punch Footswitch |
- | | Leds | 3 | 1-TX1 || | + | | Leds | 3 | 1-TX1 | Led Output |
- | | Tap | 4 | 2_Out || | + | | Tap | 4 | 2_Out | Tap Tempo Footswitch |
- | | Mode | 5 | 3_LRCLK2 || | + | | Mode | 5 | 3_LRCLK2 | Mode switch |
- | | Tail | 6 | 4_BCLK || | + | | Tail | 6 | 4_BCLK | Tail switch |
- | | On_Off | 7 | 5_IN2 || | + | | On_Off | 7 | 5_IN2 | On Off Punch Footswitch |
==== Design ==== | ==== Design ==== | ||
{{ : | {{ : | ||
+ | |||
+ | |||
+ | ==== Mode Tap Signature ==== | ||
+ | Tempo display principle in Subdivision mode. | ||
+ | {{drawio> |
punchline.txt · Last modified: 2022/05/22 18:06 by wadmin