mos6581
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mos6581 [2011/10/03 20:52] – [Power Supply] wadmin | mos6581 [2011/11/08 17:40] – wadmin | ||
---|---|---|---|
Line 306: | Line 306: | ||
==== Power Supply ==== | ==== Power Supply ==== | ||
- | SID power consumption during normal operation is 600mW. | + | SID power consumption during normal operation is around |
+ | The SID shall heat a lot during operation. The design of the analog part of the chip has been improved from 6581 to 6582/8580, allowing to reduce the operating voltage of the chip, and at the same time lowering its consumed power. | ||
+ | This also means that 6581 and 6582/8580 __are not compatible__. The power voltages listed below shall be respected, otherwise SID might be damaged. | ||
=== VCC - Pin 25 === | === VCC - Pin 25 === | ||
This pin shall be powered by a 5V DC coupled power supply. | This pin shall be powered by a 5V DC coupled power supply. | ||
- | About 70mA is drawn from VCC during normal operation. Coupling capacitor of at least 1uf is recommended for proper operation. | + | About 70mA is drawn from VCC during normal operation. Coupling capacitor of at least 10uf and filtering capacitor of 100nf are recommended for proper operation. |
Line 322: | Line 324: | ||
| 8580 | ::: | ::: | | | 8580 | ::: | ::: | | ||
- | Coupling | + | Filtering |
+ | |||
+ | === GND - Pin 14 === | ||
+ | Signal Grounds. To lower the noise, the ground shall be connected and routed on the analog part of the design. | ||
+ | |||
+ |
mos6581.txt · Last modified: 2018/08/26 09:36 by 127.0.0.1