minimalist_lfo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
minimalist_lfo [2013/02/05 19:02] – wadmin | minimalist_lfo [2013/02/05 22:24] – wadmin | ||
---|---|---|---|
Line 4: | Line 4: | ||
==== Concept ==== | ==== Concept ==== | ||
+ | This LFO has the following characteristics : | ||
+ | * Output swing from 0 to 4.8V | ||
+ | * Frequency from 0.5 to 10Hz | ||
+ | * Faded LED to visualise the LFO State | ||
+ | * Reset on the rising edge of a 5V Gate signal | ||
+ | * Low component count | ||
==== Schematic ==== | ==== Schematic ==== | ||
+ | The LFO is based on an ATTiny45/85 microcontroller. | ||
{{ : | {{ : | ||
+ | * Analog Input on Pin 3 reads the " | ||
+ | * Triangle Waveform LFO Waveform is generated by the Microcontroller | ||
+ | * LFO Output on Pin 5 (PWM Fast Mode) is filtered by R1/C1 to generate the 0-5V peak Triangle output | ||
+ | * AMP control potentiometer controls the amplitude of the LFO Output | ||
+ | * LED brightness is controlled by PWM as well | ||
+ | |||
==== PCB ==== | ==== PCB ==== | ||
{{ : | {{ : | ||
minimalist_lfo.txt · Last modified: 2018/08/26 09:36 by 127.0.0.1