hotrod
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
hotrod [2023/02/15 15:48] – [Replace power capacitors] wadmin | hotrod [2023/02/15 15:51] – [Replace power capacitors] wadmin | ||
---|---|---|---|
Line 152: | Line 152: | ||
Consider replacing them with same value/ | Consider replacing them with same value/ | ||
{{drawio> | {{drawio> | ||
+ | |||
+ | There are some complete replacement kits avaiable on the internet, which include all components that are generally worth upgrading. | ||
==== Replace burnt resistors ==== | ==== Replace burnt resistors ==== | ||
Resistors R78 and R79 of the low voltage part are 5W 470 Ohms, but are exposed to transients up to 4.9W (48V@470Ohms). Upgrading these to higher quality 10W wired resistors is encouraged. Notably, installing the resistors slightly above PCB to increase air flow is recommended. | Resistors R78 and R79 of the low voltage part are 5W 470 Ohms, but are exposed to transients up to 4.9W (48V@470Ohms). Upgrading these to higher quality 10W wired resistors is encouraged. Notably, installing the resistors slightly above PCB to increase air flow is recommended. |
hotrod.txt · Last modified: 2023/02/15 16:01 by wadmin