Differences

This shows you the differences between two versions of the page.

--- hotrod [2023/02/15 15:41] – wadmin
+++ hotrod [2023/02/15 15:43] – [Replace burnt resistors] wadmin
@@ Line 151: / Line 151: @@
 ==== Replace burnt resistors ====
-Resistors of the low voltage part are 5W 470 Ohms, but are exposed to transients up to 4.9W (48V@470Ohms). Upgrading these to 10W 470Ohms wired resistors is encouraged. Notably, installing the resistors slightly above PCB to increase air flow is recommended.
+Resistors R78 and R79 of the low voltage part are 5W 470 Ohms, but are exposed to transients up to 4.9W (48V@470Ohms). Upgrading these to higher quality 10W wired resistors is encouraged. Notably, installing the resistors slightly above PCB to increase air flow is recommended.
 {{drawio>hotrod:reschange.png}}