hotrod
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
hotrod [2023/02/15 15:24] – [Apply solder paste on weakened tracks] wadmin | hotrod [2023/02/15 15:43] – [Replace burnt resistors] wadmin | ||
---|---|---|---|
Line 151: | Line 151: | ||
==== Replace burnt resistors ==== | ==== Replace burnt resistors ==== | ||
- | Install stronger components for LV power stage. | + | Resistors R78 and R79 of the low voltage part are 5W 470 Ohms, but are exposed to transients up to 4.9W (48V@470Ohms). Upgrading these to higher quality 10W wired resistors is encouraged. Notably, installing the resistors slightly above PCB to increase air flow is recommended. |
+ | {{drawio> | ||
---- | ---- |
hotrod.txt · Last modified: 2023/02/15 16:01 by wadmin